|
Back
to download/install page
This section will assist you with
the installation of the SlipStream
Web Accelerator.
Detailed
Installation Instructions
The minimum system requirements
are a Pentium 200MHz with 64MB RAM,
and at least 5MB of hard-drive
space. SlipStream Accelerator is
supported on the following Windows
Operating Systems: Windows 95b with
Winsock 2, Windows 98, Windows 98SE,
Windows Millennium Edition (Windows
ME), Windows NT 4.0 Service Pack 6,
Windows 2000 and Windows XP. It
works with Internet Explorer 5.0 as
well as Netscape 6.0 or any later
releases of both browsers.
1. Download.
-
Download the installer to
your desktop. To download
click here.
-
Once the download has
completed, proceed to Step 2.
2. Install.
-
After downloading the
SlipStream Web Accelerator
installer onto your Desktop, an
icon as shown below will be on
your Desktop. Double-clicking on
the icon will launch the
installer.
-
The installer will guide you
through the complete setup
process.
3. Connect.
-
As this is your first time
launching the product, you will
be prompted for a username and
password. Enter the username and
password provided to you by your
ISP in the fields provided.
-
Click OK. SlipStream Web
Accelerator will connect to your
ISP.
-
After installing SlipStream
Web Accelerator, an icon as
shown below is placed in your
system tray. Acceleration will
take place immediately after any
web browser launches.
4. Browse the
Web.
-
Browse the web as you
normally would.
-
When finished, simply close
your web browser, as you
normally would, and SlipStream
Web Accelerator will remain idle
in your system tray.
-
If you want to stop the
application after browsing,
select Stop SlipStream
from the pop-up menu. If you
desire to exit the application
completely, click Exit
from the pop-up menu. The pop-up
menu can be accessed by clicking
on the icon located in the
system tray.
Back
to download/install page
|
